Vaisala CARBOCAP GMT220 SERIES Guida Utente Scaricare il pdf (Pagina 15)

Chapter 3 _______________________________________________________________ Installation

VAISALA _______________________________________________________________________ 15

Connections

To connect the GMT220:

1. Connect the nominal 24 V supply terminals (+) and (-) on the

motherboard (right-hand side, see Figure 6 below).

2. Connect the analog output (see Figure 6 below) as follows:

Terminal 0: the common wire (-)

Terminal V: voltage output signal (+)

Terminal mA: current output signal (+)

If the current output is chosen, select the output range by using the

current output jumper 4mA (see Figure 6 below). If the range of

4...20mA is chosen, connect the jumper (default). If the range of 0...20

mA is chosen, disconnect the jumper.

CAUTION

Connecting the power leads to the output terminals can seriously

damage the product.

0807-037

Figure 6 Electrical Connections and Jumpers

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 41 42

Nessun commento

Vaisala CARBOCAP GMT220 SERIES Guida Utente Pagina 15