Vaisala DRYCAP DMT340 SERIES Guida Utente Scaricare il pdf (Pagina 43)

Chapter 3 _______________________________________________________________ Installation

VAISALA _______________________________________________________________________ 43

NOTE

If the Swagelok connector is tightened at an incorrect position, it is

possible that the probe will not fit the calibration station. Be sure that the

probe position follows step 2 above.

DMT348 For Pressurized Pipelines

Due to the sliding fit the DMT348 is easy to install into and remove from

the pressurized process. The probe is especially suitable for the

measurements in pipelines. See section Ball Valve Installation Kit for

DMT348 on page 46.

0503-020

Figure 26 DMT348 Probe

Numbers refer to Figure 26 above.

1 =

Clasp nut, 27 mm hex nut

2 = Fitting body, 24 mm hex head

3 = Leak screw

The following three fitting body options are available:

- Fitting Body Set ISO1/2 with leak screw

- Fitting Body ISO1/2 solid structure (without leak screw)

- Fitting Body NPT1/2 solid structure (without leak screw)

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 168 169

Nessun commento

Vaisala DRYCAP DMT340 SERIES Guida Utente Pagina 43